Attaching Ledger Board To Metal Siding

Anchor a ledger to a masonry wall with expanding anchor bolts begin by marking a line across the wall for the ledger s top edge.

Attaching ledger board to metal siding.

Properly installing a ledger board for your deck is one of the most important structural components of building a safe and strong deck. Make the outline large enough to include space for the deck boards on top the ledger and any trim boards on the sides. Drill holes for the expanding anchors every 16 inches or as specified by local codes insert the anchors hold the ledger in place and tap it with a hammer to indent the anchor locations on its back face. The ledger board attachment for this home was challenging because it was done after the house was constructed.

Never install a ledger board over the top of siding no matter what you hear this can weaken the connection. Metal or plastic cap flashing covers the top of the ledger with a drop leg of 1 2 in. Then cut away the siding. A ledger relies on the fasteners and strength of the wood ledger board and rim board of the house to carry the deck live and dead loads.

Step 1 determine the size of the ledger board. Fastening to masonry walls. These 18 articles will teach you how to install flashing and bolt the ledger connection to the house rim. Mark the ledger length.

Attaching a deck ledger securely is only half the work of installing a ledger. The following steps will explain an easy method of removing the lap siding and attaching a ledger board. To ensure proper strength a ledger board should be made. In order to install the ledger board you usually need to remove the house s siding.

Do both sides like this then snap a chalk line in the middle but add 1 inches to the length of the ledger. Covered by the wrb and siding. Ledger boards which lend strength and support to a deck by connecting it to a house must be installed on a virtually flat surface. Set a water level on mark done for the ledger board then make another at a point longer than the length of the ledger.

Start by making an outline on the siding where you want to position the ledger board. Aluminum and vinyl siding can easily be removed with tin snips from an area one foot surrounding the ledger board location.